I can’t get my Height AND Pressure presets accurate
The method for getting your presets accurate is as follows:
When calibration is complete, you need to then save your presets in the following method
- On level ground, airout the vehicle, and begin to raise the front first.
- Raising the front to your low setting first, without going past and coming back down, all adjustmest must be made going up, not down
- When you have the front where you want it for your “low” setting, raise the back of the vehicle up to your “low” setting
- To save low, the key must be on, AND “ride height on start” must be off
- Then press and hold “LOW” until the MANUAL icon on the top left of the screen changes to AUTO and LOW changes to yellow.
- Repeat this process for “RIDE” and “LIFT“
- To build the shoot-to-height data in the ECU from ride, double tap “airout”, and then go back to ride with a single tap on the ride preset. Wait for the tank to refill, and repeat this process again twice.
